Tool-chip interface temperature measurement in interrupted and continuous oblique cutting

Kesriklioglu S., Morrow J. D., Pfefferkorn F. E.

ASME 2017 12th International Manufacturing Science and Engineering Conference, MSEC 2017 collocated with the JSME/ASME 2017 6th International Conference on Materials and Processing, California, United States Of America, 4 - 08 June 2017, vol.3 identifier

  • Publication Type: Conference Paper / Full Text
  • Volume: 3
  • Doi Number: 10.1115/msec2017-2934
  • City: California
  • Country: United States Of America
  • Keywords: Cutting, Interrupted cutting, Temperature, Thermocouple
  • Abdullah Gül University Affiliated: No


© Copyright 2017 ASME.The objective of this work is to fabricate instrumented cutting tools with embedded thermocouples to accurately measure the tool-chip interface temperature in interrupted and continuous turning. Thin-film thermocouples were sputtered directly onto the flat rake face of a commercially available tungsten carbide cutting insert using micro machined stencils and coated the measurement junction with a protective layer to obtain temperature data 1.3 μm below the tool-chip interface. Oblique interrupted cutting tests on AISI 12L14 steel were performed to observe the influence of varying cutting speeds and cooling intervals on tool chip interface temperature. An additional cutting experiment was conducted to monitor the interface temperature change between interrupted and continuous cuts.